Do I have to replace my lamps and ballasts?

No, LightBoss® installs by the electrical panel that feeds the lamps. No replacement of lamps or ballasts are necessary.  LightBoss® does not work with electronic ballasts.

Will LightBoss® damage my lights and/or ballasts?

No, in fact, the reduced energy used will actually lengthen the lives of both.  LightBoss® is designed to reduce wear and tear on lights and ballasts. They last longer and need to be replaced less often.

Who installs LightBoss®?

Installation should be by a licensed electrical contractor. In addition to a detailed installation manual, LightBoss® will provide initial and continued support for any installation.

Is LightBoss® a "Hi-Low" system?

It can be. However, LightBoss® is the first HID dimming system that offers variable dimming from 100% power to 55% brightness. Power may be reduced incrementally. 

Can I use automatic external devices to control the dimming function?

Yes. LightBoss® up and down control can be initiated by timers, motion detectors, occupancy sensors, photocells, light sensors and any combination of these devices.  We offer and sell these devices in complete systems.

If LightBoss® fails will I be without lighting until it is repaired?

No. LightBoss® has built-in technonogy and by-pass circuitry that assures fail-safe operation.  In the event of an internal system problem, the bypass circuitry will provide input line power directly to the lighting circuit.

How long will it take, in energy savings, to pay back my investment in LightBoss®?

Typical Return on Investment [ROI] is less than 24 months.  If you receive energy rebates it is significantly less.

Can I run LightBoss® from my energy management system?

Yes, in the automatic mode, LightBoss® will take a 0-10v, 0-5v or 4-20 milliamp signal from an energy management system. Based on the signal sent, any level can be accessed at any time.

Lamps need to start with full power, will LightBoss® accommodate that requirement?

Yes, LightBoss® is equipped with an automatic bypass circuit. Bypass is initiated when Lamps turn on, allowing full power to the lamps during warm up. After warm up, LightBoss® reduces voltage to the lamps based on the customer selected levels.